Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Cracked heat exchangers get flagged immediately as a safety issue, not just a repair line item.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
No push toward replacement when a repair genuinely solves the problem.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Dundee, OR.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Dundee, OR.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. This is one of the most requested furnace repair calls we get across Dundee, OR.
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Gas odor reports get immediate safety instructions before dispatch details.
We confirm your Dundee address and a realistic arrival window.
Flat-rate quote follows the confirmed fault, before repair begins.
Heat exchanger findings are documented clearly regardless of outcome.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
We'll walk you through options including repair versus replacement honestly.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Yes — our technicians are trained and certified on both fuel types.
Gas odor calls receive top dispatch priority.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Dundee, OR to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Dundee Service